2.Installation and connection
12
(3) Use the 4 included rack fi xing screws and nuts (medium-sized) to securely fasten the front
(the side displaying “L” or “R”) and back of the support angles to the server rack. (JIS stan
dards)
③
For JIS standards, use 4 sets of screws and nuts to fasten the left and right support angles
(one screw and nut at the back and front of each support angle) (middle screw holes).
③
(4) Use the 8 included ear bracket mounting screws (2 sets of 4 screws) to securely fasten the
ear brackets to the left and right sides of the UPS.
④
The support angles cannot be attached to special EIA/JIS racks.
(2) Adjust the length of support angles to suit the server rack, and then securely tighten the
screws that were half-tightened in step 1.
②
3
2
2
3
Rack fixing screws 8 (EIA standards)
4 (JIS standards)
Adjust the length to
suit the server rack
and tighten securely.
Ear bracket mounting screws
4
4
To Next Page
Loading...
