78
An SNMP/Web card can be loaded into the card slot on the back of the unit. Remove the contact
signal card that the unit came equipped with, and plug the SNMP/Web card in its place. Store the re-
moved contact signal card in a safe place.
•
SNMP/Web card (model number: SC20G), sold separately
(1) Turn OFF the power switch and turn OFF the INPUT PROTECTION (AC input overcurrent
protection switch) on the back of the unit. Remove the 2 screws, and carefully pull out the
contact signal card.
8-1
Adding an SNMP/Web card
Using an SNMP/Web card
88
(2) Carefully insert the SNMP/Web card (model number: SC20G), and securely tighten the 2 screws.
* Replace with BU50SW/BU75SW/BU100SW/BU150SW/BU1002SW/BU3002SW brackets.
BU200RW/BU300RW
To Next Page
Loading...
