Omron SYSDRIVE 3G3JV - Ground Wiring

3-6
Parameter
No. (Reg-
ister No.
(Hex))
MemoChanges
during
opera-
tion
Default
setting
Setting
range
DescriptionName
n21
(0115)
Fre-
quency
refer-
ence 1
Used to set internal frequency refer-
ences.
Note Frequency reference 1 is en-
abled in remote mode with
0.0 to max.
frequency
6.0 Yes
n22
(0116)
Fre-
quency
refer-
ence 2
abled
in
remote
mode
with
n03 for frequency reference
selection set to 1.
Note These frequency references
are selected with multi-step
0.0 Yes
n23
(0117)
Fre-
quency
refer-
ence 3
are se
l
ec
t
e
d
w
ith
mu
lti
-s
t
ep
speed references (multi-func-
tion input).
0.0 Yes
n24
(0118)
Fre-
quency
refer-
ence 4
0.0 Yes
n25
(0119)
Fre-
quency
refer-
ence 5
0.0 Yes
n26
(011A)
Fre-
quency
refer-
ence 6
0.0 Yes
n27
(011B)
Fre-
quency
refer-
ence 7
0.0 Yes
n28
(011C)
Fre-
quency
refer-
ence 8
0.0 Yes
n29
(011D)
Inching
frequen-
cy com-
mand
Used to set the inching frequency
command.
Note The inching frequency com-
mand is selected with the
inching command (multi-func-
tion input). The inching fre-
quency command takes pre-
cedence over the multi-step
speed reference.
6.0 Yes
List of Parameters Chapter 3