3-2SectionMemory Packs
28
4. On
the
printed circuit board there is a socket for the EPROM Chip. On the
socket
you will find a notch. Align the notch on the socket with the notch on
the
EPROM Chip
and mount the EPROM Chip to the socket as shown be
-
low.
Notch
5. Reassemble
the
EPROM Pack in the reverse order of disassembly
. During
reassembly,
ensure
that the circuit board is inserted along the guides on the
top
and bottom of the Pack housing and that the projections on the housing
fit
into the holes in the holding bracket. Be sure to lock the holding bracket
into
the right side of the housing. When
reassembled, the Pack should ap
-
pear as shown below.
Circuit
board guide
Bracket
Hole
Holding bracket
Circuit board
Circuit board guide
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
Need help?
General
