3-2SectionMemory Packs
27
3-2 Memory Packs
The
CPU has a removable Memory Pack that stores the user program. Memory
Packs
are available with three types of
memory; EPROM, EEPROM, and RAM
(refer
to
Section
2-6 Memory Packs
). If this is your
first C200H, then you must
have
a RAM Pack in order to write and test the program you are going
to use. If
this is not your first C200H and you have a complete, tested program already,
you can copy the program to an EPROM or EEPROM Pack for use on this
C200H.
The EEPROM chip can be written to without removing the chip from the
Memory Pack by using an appropriate peripheral device (refer to
Appendix C
Standard
Models
). The EPROM Chip may be programmed using a PROM W
rit-
er or a FIT Ladder Pack. Then the EPROM Chip must be mounted inside the
EPROM Pack.
Note Only
PROM W
riter Model C500-PR
W06 may be used with the SYSMAC C200H.
After
the data has been written to the EPROM Chip, mount it to the inside of the
EPROM Pack by following these steps.
1, 2, 3...
1. Remove the cover of the EPROM Pack as shown below.
2. Unlock
the holding bracket and
slide it upward to remove it as shown below
3. Pull the printed circuit board out of the EPROM Pack.
How to Mount an
EPROM Chip to the
Memory Pack
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
Need help?
General
