9. Program
49
9. Program
Th he program and protocol macro data that are used in this
do
9.1. Overview
is se
cum
ction
explains the details on t
ent.
This section explains the specifications and functions of the program and protocol macro data
that are used to check the connection between the RFID Reader/Writer (hereafter, referred to
as "destination device") and the PLC (Serial Co erred to as
This program and protocol macro data send and receive the “Read product type and version”
command to/from the destination device by using the protocol macro function of the SCU Unit
a n error end.
A ram means a normal end of the communications sequence of the
p
A of the communications sequence of the protocol macro and
destination device error (detected with the response data from the destination device).
In this section, the "&" prefix is added to decimal data and the "#" prefix is added to
h is necessary to distinguish between decimal and hexadecimal data.
(e.g., "&1000
mmunications Unit) (hereinafter, ref
“
SCU Unit”).
nd detects a normal end or a
d of this prog normal en
rotocol macro.
n error end means an error end
exadecimal data when it
" for decimal and "#03E8" for hexadecimal)
Additional Information
OMRON has confirmed that normal communications can be performed using this program
and protocol macro data under the OMRON evaluation conditions including the test system
configuration, version of each product, and product Lot, No. of each device which was used
for evaluation.
OMRON does not guarantee the normal operation under the disturbance such as electrical
noise and the performance variation of the device.
To Next Page
Loading...
Need help?
General
