9. Program
68
ttings
s, and Error
rocess. The sequence of this protocol macro data includes Step No.00 only.
9.6.4. Step Settings
This section describes the step settings for communications sequence No. 900. The se
include Retry Count, Send/Receive Messages (message names), Next Proces
P
Additional Information
Attributes in the CX-Protocol Operation
(Cat. No. W344).
For details on the sequence settings, refer to 3-3 Step
Manual
●R
ction describes the Retry count of the step. The step is retried for the specified
umber of times (0 to 9 times) when an error occurs. If the error occurs after retries, the step
The retry count is enabled for the Send&Receive command only.
<Step setting screen>
etry Count setting
This se
n
moves to Error Process.
><Settings
Step No. Retry count
0 3 0
●Send/receiv massag
o se
pre-registered send message name and matrix name are selected.
e message (
n describes the
e name) settings
This secti ttings for the Send/Receive Messages of the step. Here, a
<Step setting screen>
<Settings>
Step No. Send message Receive message
00 SD_GETRVER <GetVer_Mat>
*<> in the receive message column indicates the matrix name. When there are two or
more receive message formats, use the matrix.