EasyManua.ls Logo

Omron SYSMAC CJ1W-SCU41-V1

Omron SYSMAC CJ1W-SCU41-V1
781 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
212
Protocol Conversion Section 6-5
6-5 Protocol Conversion
6-5-1 Types of Protocol Conversion
Note For details on FINS response end codes, refer to Troubleshooting Using FINS
End Codes
in 11-3-2 Serial Gateway (Serial Gateway or Protocol Macro
Mode)
.
6-5-2 Converting FINS to CompoWay/F
OMRON Components connected serially to a PLC via CompoWay/F can be
accessed from the CPU Unit or PT using CompoWay/F commands enclosed
in FINS messages.
Sent FINS message: FINS header + FINS command code 2803 hex +
CompoWay/F command
Message after conversion: CompoWay/F command
Type of
conversion
(from FINS)
Frame before conversion Processing at
Board/Unit
Protocol after
conversion
(using serial
communica-
tions)
Target (commu-
nications part-
ner)
Destination
address
FINS
command
FINS data
Converting to
CompoWay/F
Serial port
number on
Board/Unit
2803 hex CompoWay/F
command
CompoWay/F
command with
FINS header
removed sent to
serial port.
CompoWay/F
command
OMRON Compo-
nent (e.g., Tem-
perature
Controller, Digital
Panel Meter, or
Smart Sensor)
Converting to
Modbus-RTU
2804 hex Modbus-RTU
command
Modbus-RTU
command with
FINS header
removed sent to
serial port.
Modbus-RTU
command
Modbus-RTU
Slave-compatible
device (including
OMRON 3G3JV,
3G3MV, and
3G3RV Inverters)
Converting to
Modbus-ASCII
2805 hex Modbus-ASCII
command
Modbus-ASCII
command with
FINS header
removed sent to
serial port.
Modbus-ASCII
command
Modbus-ASCII
Slave-compatible
device (e.g., tem-
perature control-
ler, indicator, or
power monitor)
Converting to
Host Link FINS
Any address
except Board/
Unit’s serial
port number.
User-speci-
fied
User-specified Transfers FINS
command inside
Host Link header
and terminator.
FINS com-
mand for Host
Link communi-
cations
OMRON PLC
(CS/CJ Series, or
CVM1/CV
Series)
FINS message
FINS header
CompoWay/F command
2803
(Via network or CPU bus)
CompoWay/F command
CompoWay/F command
(RS-232C or RS-422A/485)
CPU Unit
(CMND(490)
instruction) or
PT (Program-
mable Termi-
nal)
CompoWay/F command encapsulated
using FINS command 2803 hex
Serial Com-
munications
Unit/Board
CompoWay/F-
compatible
OMRON
Component

Table of Contents

Related product manuals