142
SECTION 5
V680 Commands
RFID System
User’s Manual
SECTION 5
Communications
COMMAND PROCESSING TERMINATE (AA)
The COMMAND PROCESSING TERMINATE command cancels any command except for polling
commands and returns the ID Control to command standby status.
1:1 Protocol
1:N Protocol
Processing cancel timing Indicates the timing when polling processing was cancelled.
“00”: Command was cancelled before a Tag was detected.
“01”: Command was cancelled after a Tag was detected.
Processing cancel timing Indicates the timing when polling processing was cancelled.
“00”: Command was cancelled before a Tag was detected.
“01”: Command was cancelled after a Tag was detected.
AA
2
2
* CR
01/2
Process
desig-
nation
11
Terminator
Antenna
designation
Command
code
Command
AA
22
2
* CR
01/2
11
2
0
Terminator
×
Command
code
End code
Antenna
desig-
nation
Resend flag
Processing
cancel
timing
××
Response
AA
2
2
*
CR
01/2
11
@
2
0
11
2
FCS
Command
code
Terminator
Antenna designation
Controller No.
×
Process
desig-
nation
××
×
Command
AA
22
2
* CR
01/2
11
2
0
@
2
0
11
2
FCS
Command
code
Terminator End code
Antenna
desig-
nation
Resend flag
Controller No.
×
Processing
cancel timing
×
×
×
×××
Response
To Next Page
