235
RFID System
User’s Manual
SECTION 5
V600 Commands
SECTION 5
Communications
List of End Codes
End codes are expressed in 2-digit hexadecimal.
Refer to Error Lists for details on error codes
p. 240
Classification End code Name
Normal end 00 Normal end
74 Polling command received or polling command query (no results information).
75 Auto command cancelled. (Processing cancelled before a Tag was detected.)
Polling command cancelled. (Processing cancelled before a Tag was detected.)
Normal end for DATA CHECK command or OVERWRITE COUNT CONTROL command
(no error)
76 Auto command cancelled. (Processing cancelled after a Tag was detected.)
Polling command cancelled. (Processing cancelled after a Tag was detected.)
Host communications
error
10 Parity error
11 Framing error
12 Overrun error
13 FCS error
14 Format error
Execution condition error
18 Frame length error
Tag communications error 70 Tag communications error
71 Mismatch error
72 Tag missing error
76 Copy error
7A Address error
7C Antenna not connected error
7D Write protected error
Tag memory warning
76
Error end (verification error or overwrite count exceeded) for DATA CHECK
command or OVERWRITE COUNT CONTROL command
System error 92 Antenna internal power supply voltage error
93 Internal memory error
To Next Page
Loading...
