ONEAC ONePlus Series - Typical Runtimes; Battery Considerations

Battery Considerations
ONePlus UPS User Instruction Manual 23
Typical Runtimes
Table 3. Typical ONePlus UPS Runtimes
Battery
Considerations
NOTE:To obtain new batteries, contact ONEAC
Technical Services at (847) 816-6000, option 3 or
toll free at (800)-327-8801, option 3. In Europe, dial
+44 (0) 1235 534721.
ONePlus batteries are user replaceable. It is a safe
procedure that is isolated from electrical hazards.
The UPS and attached loads can be left powered
“ON” during the procedure. If the unit is “ON,” the
audible alarm will sound when the battery is
disconnected and the yellow and red LEDs will
blink.
Although not necessary, AC power can be removed
for battery replacement. Press the power switch ( )
for 2 seconds to turn the unit “OFF” AND unplug the
UPS from the AC power source.
NOTE:The UPS cannot protect against power
outages while the batteries are disconnected.
Before replacing batteries, read all warnings below.
WARNING:Due to the presence of electrical charge,
batteries can present a risk of electrical shock or
burn.
To minimize the risk of electrical shock:
• Remove watches, rings or other metal objects;
• Use tools with insulated handles;
Typical
Runtime by
System Load
ONE254AG-SE ONE404AG-SE ONE604AG-SE ONE1004AG-SE
VA LOAD RUNTIME
Half Load 22 min. 12 min. 12 min. 12 min.
Full Load 8 min. 5 min. 5 min 5 min.
NOTE: Due to application specific conditions, your actual run time may be different.