4 Set-up
When only monitoring tasks (to the exclusion of any predictive maintenance tasks)
are to be assigned to MVX, the OneProd CSM set-up interface should be used.
This interface is used to set up MVX; it does not allow for visual display or processing
of measurement results.
To assign predictive maintenance tasks to MVX, one should use MVX jointly with the
ONEPROD NEST ANALYST (XPR) predictive maintenance software program.
This platform will perform the set up of MVX, as well as the processing of
measurement results.
In both cases, the communication between MVX and the computer hosting OneProd
CSM or ONEPROD NEST ANALYST (XPR) used an Ethernet connection: existing
network or point-to-point connection.
4.1 Setup with OneProd CSM
While remaining a user-friendly interface, CSM can be used to set up simple, as well
as more specific, monitoring tasks.
The use of ONEPROD CSM is described in detail in a dedicated user manual.
Note:
CSM isn’t suitable to setup real time indicators
CSM isn’t suitable to setup SFI indicator (Shock Finder
TM
).
CSM isn’t suitable to setup GCI indicator (Gearbox Condition Index
TM
)
CSM isn’t suitable to setup time wave signals
4.2 Set-up with ONEPROD XPR
XPR is a global, multi-technique, performing predictive maintenance software
package.
In particular, it allows for the management of production assets under both “off-line”
and “on-line” monitoring.
There is a separate user manual devoted to ONEPROD NEST ANALYST (XPR).
CAUTION
Although set-up structures are compatible, we strongly recommend that the use of
XPR and CSM never be combined to set up a MVX module.
To Next Page
Loading...