Table of contents
1 Introduction ....................................................................................................... 7
1.1 Hazardous areas .......................................................................................... 7
1.2 Installation .................................................................................................... 7
1.3 Version compatibility .................................................................................... 8
1.4 Hardware identification ................................................................................. 9
2 Evolutions ........................................................................................................ 10
2.1 Main evolutions of firmware version 5.4.0-7 ............................................... 10
2.2 Main evolutions of MVX version 5.1 ........................................................... 10
2.3 Main evolutions of MVX version 5.0 ........................................................... 10
2.3.1 Monitoring on 100% of the signal ........................................................ 10
2.3.2 “Time waves on event” signals recording ............................................ 13
2.3.3 DAT option performance optimisation ................................................. 14
2.3.4 BGI: for the monitoring of structures ................................................... 14
2.3.5 GCI: for particle counting..................................................................... 14
2.4 Main evolutions of MVX version 4 .............................................................. 15
2.4.1 New « Shock Finder
TM
» indicator (SFI) ............................................. 15
2.4.2 Increase of the efficiency..................................................................... 16
2.5 Main evolutions of MVX version 3.1 ........................................................... 16
2.5.1 Compatibility with the ESA analysis by ONEPROD-System ............... 16
2.5.2 Short-term memory ............................................................................. 16
2.5.3 OPC parameters via XCOM ................................................................ 17
2.5.4 Priority management ........................................................................... 17
2.5.5 Alarm triggering delay ......................................................................... 17
2.5.6 Vector tracking .................................................................................... 18
3 MVX Operating ................................................................................................. 19
3.1 Principle ..................................................................................................... 19
3.2 Operating conditions .................................................................................. 19
3.3 Operating in “Monitoring” mode .................................................................. 19
3.4 Operating in “Predictive Maintenance” mode ............................................. 20
4 Set-up ............................................................................................................... 21
4.1 Setup with OneProd CSM .......................................................................... 21
4.2 Set-up with ONEPROD XPR ...................................................................... 21
To Next Page
Loading...
