Onkyo DR-UN7

68
Using the Timer Functions—Continued
• You can use this function to cancel or resume the pro-
grammed timer operation.
• You cannot program the timers unless the clock is set.
Tip:
You can also perform the operation by using the TIMER
and cursor / on the remote controller.
Tip:
You can also perform the operation by using the TIMER,
cursor / and ENTER on the remote controller.
Switching the Timer On and Off
1
Repeatedly press TIMER to display
the desired timer number.
If the timer number is lit, the correspond-
ing timer has been programmed.
2
Turn MULTI JOG to switch the
timer on or off.
After the timer is switched on or off, the
unit displays the previous screen.
2
1
Display
1
or
Viewing the Timer Settings
1
Repeatedly press TIMER to display
the desired timer number, then
press MULTI JOG.
2
Press MULTI JOG to view the sub-
sequent timer settings.
Repeatedly pressing MULTI JOG
enables you to view the subsequent set-
tings.
Notes:
• You can change the settings by turning
MULTI JOG.
• If the timer is turned off and you
change the settings, the timer is auto-
matically turned on.
Check all the settings. If you do not
change any settings, the unit returns to
the previous display.
To return to the previous display, press
EDIT/NO/CLEAR.
1, 2
1
Display