Onkyo DR-UN7 User Manual

80
Recording
The copyright laws prohibit using your recordings without consent of the copyright owner, except for the purpose of
your personal entertainment.
1
Press INPUT on the DVD receiver or the remote controller to select the recording
source component.
2
Prepare the recording component.
• Place the recording component in record standby mode.
• Adjust the recording level on the recording component.
3
Start recording.
• Start playing the source component selected in Step 1.
Notes:
• Do not change the input selection during recording. Otherwise, the recording cannot be made
correctly.
• Set the input source (page 28) to perform Synchro recording, or other system recording using
Onkyo components that feature the connector.
• Select STEREO for the listening mode, when you record in analog form the signals from the
built-in DVD or other devices connected to the DIGITAL (OPTICAL) terminal.
• The recording level differs depending on the individual sources; you should adjust the level on
the recording device.
1
1
DVD receiver
Remote
controller

Onkyo DR-UN7 Specifications

Power

power supply	AC 120 V, 60 Hz
power consumption	115 W
stand-by power consumption	0.2 W

Operating Environment

operating temperature	5 ˚C–35 ˚C
operating humidity	5 %–85 %
tuning frequency range	87.5 MHz–107.9 MHz

Audio Specifications

signal to noise ratio	100 dB (LINE, IHF-A)
frequency response	10 Hz–100 kHz/±3 dB (LINE)
total harmonic distortion	5 % (Power Rated)

Weight and Dimensions

dimensions	205 W x 147 H x 353 D mm
weight	5.4 kg