15
Remote Controller
—Continued
For further information, see the pages in parentheses.
A
Standby/On indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
With the Auto Standby function, the SKW-960
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-960 automatically
enters Standby mode.
B
OUTPUT LEVEL control (50)
Adjusts the volume of the subwoofer.
C
LINE INPUT (21)
Connects to the AV receiver’s SUBWOOFER PRE
OUT jack with the supplied RCA cable.
Note:
• The Auto Standby function turns the subwoofer on
when the input signal exceeds a certain level. If the
Auto Standby function does not work reliably, try
increasing or decreasing the subwoofer output level
slightly on the AV receiver (see page 79).
• The front grilles are not designed to be removed so do
not attempt to remove them forcibly, as this will dam-
age them.
Subwoofer (SKW-960)
1
23
■ Rear
To wall outlet
■ Front
HT-S9100THXEn.book Page 15 Friday, June 27, 2008 4:00 PM
To Next Page
Loading...
Need help?
General
