46
First Time Setup
—Continued
If you connect a video component to an HDMI IN, you
must assign that input to an input selector. For example,
if you connect your DVD player to HDMI IN 1, you
must assign HDMI IN 1 to the DVD input selector.
These are the default assignments.
Notes:
• Each HDMI IN cannot be assigned to more than one
input selector.
• When an HDMI IN is assigned to an input selector as
explained here, the digital audio input for that input
selector is automatically set to the same HDMI IN.
See “Digital Input Setup” on page 47.
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
HDMI Input Setup
Input selector Video input
DVD HDMI1
VCR/DVR HDMI2
CBL/SAT HDMI3
AUX - - - - -
TAPE - - - - -
CD - - - - -
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Input
Assign,” and then press
[ENTER].
3
Use the Up and Down [ ]/[ ]
buttons to select “1. HDMI Input,”
and then press [ENTER].
4
Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and use the Left and Right
[ ]/[ ] buttons to select:
HDMI1:
Select if the video compo-
nent is connected to HDMI
IN 1.
HDMI2:
Select if the video compo-
nent is connected to HDMI
IN 2.
HDMI3:
Select if the video compo-
nent is connected to HDMI
IN 3.
HDMI4:
Select if the video compo-
nent is connected to HDMI
IN 4.
- - - - -:
Select if you’re not using the
HDMI OUT.
5
Press the [SETUP] button.
Setup closes.
HT-S9100THXEn.book Page 46 Friday, June 27, 2008 4:00 PM
To Next Page
Loading...
Need help?
General
