EasyManuals Logo
Home>Onkyo>Receiver>HT-RC430

Onkyo HT-RC430 User Manual

Onkyo HT-RC430
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Turning On & Basic Operations
En-27
About Listening Modes
The AV receiver’s listening modes can transform your
listening room into a movie theater or concert hall, with
high fidelity and stunning surround sound.
Explanatory Notes
a Front speakers
b Center speaker
c Surround speakers
d Subwoofer
Input Source
The following audio formats are supported by the listening
mode.
*1
The AV receiver outputs this source in 5.1-channel surround
sound.
Speaker Layout
The illustration shows which speakers are activated in each
channel. See “Sp Config (Speaker Configuration)” for the
speaker setup ( page 38).
b
a
c
d
A
This is mono (monophonic) sound.
S
This is stereo (stereophonic) sound. Two
independent audio signal channels are reproduced
through two speakers.
D
This is 5.1-channel surround sound. This surround
system has five main channels of sound and a sixth
subwoofer channel (called the point-one channel).
F
*1
This is 7.1-channel surround sound. This is a further
sound enhancement to 5.1-channel sound with two
additional speakers that provide greater sound
envelopment and more accurate positioning of
sounds.
Z
X
C

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo HT-RC430 and is the answer not in the manual?

Onkyo HT-RC430 Specifications

General IconGeneral
Receiver typeSurround
Frequency range5 - 100000 Hz
Input sensitivity200 mV
Audio output channels5.1 channels
Signal-to-Noise Ratio (SNR)100 dB
Total Harmonic Distortion (THD)0.08 %
Dynamic power per channel (3 Ohm)160 W
Dynamic power per channel (4 Ohm)125 W
Dynamic power per channel (8 Ohm)85 W
Power output per channel (20-20KHz@8 Ohm)60 W
HDMI in4
Audio (L/R) in6
Composite video in5
Digital audio coaxial in1
Component video (YPbPr/YCbCr) in2
Connectivity technologyWired
Speakers connectivity typeClamp terminals
Ethernet LANNo
AM band range530 - 1710 kHz
FM band range87.5 - 107.9 MHz
Supported radio bandsAM, FM
Preset stations quantity40
3DYes
Supported video modes1080p
Display-
Product colorBlack
Audio decodersDolby Digital Plus, Dolby TrueHD, DTS-HD Master Audio
Damping factor60
Apple docking compatibilityiPhone, iPod
AC input voltage120 V
AC input frequency60 Hz
Power consumption (standby)0.2 W
Power consumption (typical)40 W
Weight and Dimensions IconWeight and Dimensions
Depth318 mm
Width435 mm
Height150 mm
Weight7600 g

Related product manuals