102
Zone 2—Continued
Adjusting the Volume for Zone 2
To Mute Z o ne 2:
Press the remote controller’s [ZONE 2] button, followed
by the [MUTING] button. To unmute Zone 2, press the
remote controller’s [ZONE 2] button again, followed by
the [MUTING] button, or adjust the volume for Zone 2.
Notes:
• Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 SPEAKERS terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it’s con-
nected to an analog input.
• While Zone 2 is being used, listening modes that need
surround back speakers (i.e., Dolby Digital EX, DTS-
ES, and THX Select2 Cinema) are unavailable.
• While Zone 2 is on, functions will not work.
• You can’t select different radio stations for Zone 2 and
the main room. For example, if you have an FM sta-
tion for the main room, that station will also be used in
Zone 2.
On the remote controller, press
the [ZONE 2] button, and then
use the [LEVEL–] and [LEVEL+]
buttons.
On the AV receiver/AV amplifier,
use the ZONE 2 LEVEL [ ]/[ ]
buttons.
If your Zone 2 speakers are connected
to a receiver or integrated amp in Zone
2, use its volume control to adjust the
volume.
ZONE 2 LEVEL ,
Remote
controller
AV receiver/
AV amplifier
TX-SR705_En.book Page 102 Monday, May 28, 2007 2:13 PM
To Next Page
Loading...
