11
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Front Panel≫ Rear Panel≫ Remote≫
1. ON/STANDBY button
2. HYBRID STANDBY indicator: Lights up when any of the following functions is
working or enabled in standby state of this unit. When this indicator is lighting,
the power consumption in standby state increases, however, the increase in
power consumption is minimized by entering the HYBRID STANDBY mode
where only the essential circuits operate.
– HDMI CEC ( p89)
– HDMI Standby Through ( p89)
– USB Power Out at Standby ( p93)
– Network Standby ( p94)
– Bluetooth Wakeup ( p94)
3. Remote control sensor: Receives signals from the remote controller.
• The reception range of the remote controller is within a distance of approx.
16´/5 m, and an angle of 20° in vertical direction and 30° to right and left.
4. Display ( p12)
5. SETUP button: You can display advanced setting items on the TV and the
display to have a more enjoyable experience with this unit. ( p78)
6. Cursor buttons ( / / / ) and ENTER button: Select an item with the
cursors, and press ENTER to conrm your selection. When using TUNER, use
them to tune in to stations. ( p61)
7. RETURN button: Returns the display to the previous state while setting.
8. VOLUME
9. PURE AUDIO button/indicator: Used to switch to the Pure Audio listening
mode. The LED lights when it is on, the display turns off, and the "Bass" and
"Treble" settings are disabled.
• Pure Audio mode cannot be selected when using the Multi-zone feature.
Activating the Multi-zone feature while this mode is selected automatically
switches the listening mode to Direct.
10.
PHONES jack: Connect headphones with a standard plug (ø1/4″/6.3 mm).
11.
SPEAKER A/B button : Select whether to output audio from SPEAKER A,
SPEAKER B or both.
12.
ZONE 2 button: Controls the multi-zone function. ( p69)
13.
OFF button: Switches the multi-zone function off. ( p69)
14.
INPUT SELECTOR dial: Switches the input to be played.
15.
BASS dial: Adjusts the bass.
16.
TREBLE dial: Adjusts the treble.
17.
BALANCE dial: Adjusts the balance of the sounds output from the left and right
speakers.
18.
MY INPUT dial/indicators: You can register settings conditions such as the
current input selection or listening mode, and then recall them. The indicator
corresponding to the selected MY INPUT number lights. ( p73)
19.
SETUP MIC jack: Connect the supplied speaker setup microphone. ( p101)
20.
USB jack: A USB storage device is connected so that music les stored in it
can be played. You can also supply power (5 V/0.5 A) to USB devices with a
USB cable.
To Next Page
Loading...
