Onkyo TX-8390 - To ARC TV

26
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
To ARC TV
If the TV supports the ARC (Audio Return Channel) function (*), use only the
HDMI cable to connect with the TV. Use the ARC-compatible HDMI IN jack of the
TV for connection. You connect the HDMI cable to the HDMI OUT jack labeled
"ARC"on the receiver side.
• Another TV or projector can be connected to the HDMI OUT SUB jack. Switch
between MAIN and SUB using the "AUDIO Menu" ( p97). Note that this
jack is not ARC-compatible.
• If devices with different resolutions are connected to HDMI OUT MAIN jack
and SUB jack, images are output with the lower resolution.
• If a 4K high-quality video is played, use a Premium High Speed HDMI Cable
or Premium High Speed HDMI Cable with Ethernet whose package has a
"PREMIUM Certied Cable" label. Furthermore, in "Switching the HDMI 4K
Signal Format Input and Output by this Unit" ( p77), change the setting
value to "Enhanced".
Setup
• Settings are required to use the ARC function. Select "Yes" for "3. ARC Setup"
in Initial Setup (
p100). If "No, Skip" is selected, settings are required in
the Setup menu after Initial Setup is completed. Press SETUP on the remote
controller, and set "5. Hardware" - "HDMI" - "Audio Return Channel" to "On". (
p90)
• For detailed settings for TV connection, CEC function and audio output, refer
to the instruction manual of the TV.
(*) ARC function: Transmits the audio signals of the TV via an HDMI cable, and
plays the audio of the TV on this unit. Connection to an ARC-compatible TV is
complete with one HDMI cable. To check if the TV supports the ARC function,
refer to the instruction manual of the TV, etc.
IN(ARC)
a
TV
a HDMI cable