Onkyo TX-8390 - Connecting a Pre-main Amplifier (ZONE 2)

31
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Connecting a Pre-main Amplier (ZONE 2)
You can enjoy 2-ch audio in the separate room (ZONE 2) while performing
playback in the main room (where this unit is located). Use an analog cable
to connect the ZONE 2 LINE OUT jack of this unit and the LINE IN jack of the
premain amplier in the separate room. The same source can be played back in
the main room and ZONE 2 simultaneously. Also, different sources can be played
back in both rooms.
• To output audio from an externally connected AV component to ZONE
2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not
equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or
analog audio cable. Also, the audio from externally connected AV components
can be output to ZONE 2 only when the audio is analog or 2ch PCM signal.
When the AV component is connected to this unit with a digital coaxial cable or
digital optical cable, change the audio output of the AV component to the PCM
output.
Setup
• Settings are required to output audio to ZONE 2. Press SETUP on the remote
controller, and set "2. Speaker" - "Conguration" - "Zone 2 Lineout" (
p85)
to "Zone 2".
a
LINE
IN
Premain Amp.
a Analog audio cable