Onkyo TX-8390 - 2. Speaker

85
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
2. Speaker
 1. Conguration
Change the settings of connection environment of the speakers.
Setting Item Default Value Setting Details
Subwoofer Yes Set whether a subwoofer is connected or not.
"Yes": When a subwoofer is connected
"No": When a subwoofer is not connected
Speaker B A/B Set whether you are connecting another set of
front speakers to use as a Speaker B System, or
connecting speakers supporting bi-wiring.
"A/B": When bi-wiring connection is not used for
the front speakers
"Bi-Wiring": When bi-wiring connection is used for
the front speakers
Zone 2 Lineout Zone 2 Set an output destination of the audio output from
ZONE 2 LINE OUT jack.
"Zone 2": When connecting a pre-main amplier in
a separate room (ZONE 2)
"Front": When connecting a power amplier
Speaker
Impedance
6 ohms or above Set the impedance (Ω) of the connected speakers.
"4 ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance.
Or when outputting audio simultaneously from
2 speaker systems connected to both the
SPEAKERS A/B terminals.
"6 ohms or above": When all the connected
speakers have an impedance of 6 Ω or more
• For impedance, check the indications on the
back of the speakers or their instruction manual.
 2. Crossover
Change the settings of crossover frequencies.
Setting Item Default Value Setting Details
Front 100 Hz Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• If "Conguration" - "Subwoofer" is set to "No",
"Front" will be xed to "Full Band".
Double Bass On This can be selected only when "Conguration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Full Band".
Bass output is boosted by feeding bass sounds
from the front right and left, and center speakers to
the subwoofer.
"On": Bass output is boosted.
"Off": Bass output is not boosted.
• This function is not automatically set even if
AccuEQ Room Calibration is performed.