86
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
3. Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value Setting Details
Front Left 12.0 ft/3.60 m Specify the distance between each speaker and
the listening position.
Front Right 12.0 ft/3.60 m Specify the distance between each speaker and
the listening position.
Subwoofer 12.0 ft/3.60 m Specify the distance between each speaker and
the listening position.
• Default values vary depending on the regions.
• The unit of distance can be changed by pressing the MODE button on the remote
controller. When using the unit "feet", the setting is available in increments of 0.1 ft from
0.1 ft to 30.0 ft. When using the unit "meter", the setting is available in increments of 0.03
m from 0.03 m to 9.00 m.
4. Level Calibration
Adjust the volume level of each speaker.
Setting Item Default Value Setting Details
Front Left 0.0 dB Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Front Right 0.0 dB Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Subwoofer 0.0 dB Select a value between "-15.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
5. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of different sound ranges for each speaker. You can set three
different equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to ve bands for the Subwoofer and nine bands
for the other speakers.
Setting Item Default Value Setting Details
Front 0.0 dB
After selecting the speaker frequency between "25
Hz" and "16 kHz" with the cursors
/
, adjust the
volume of that frequency between "-6.0 dB" and "+6.0
dB" with
/
.
Subwoofer 0.0 dB
After selecting the speaker frequency between "25
Hz" and "16 kHz" with the cursors
/
, adjust the
volume of that frequency between "-6.0 dB" and "+6.0
dB" with
/
.
• This cannot be selected if "Conguration" -
"Subwoofer" is set to "No".
• Depending on the input source or listening mode setting, the desired effect may not be
achieved.
To Next Page
Loading...
