Onkyo TX-8390 - General Specifications

118
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
General Specications
 Amplier Section
Rated Output Power (FTC) (North American)
With 8 ohm loads, both channels driven, from 20-20,000 Hz; rated 135
watts per channel minimum RMS power, with no more than 0.08% total
harmonic distortion from 250 milliwatts to rated output.
Rated Output Power (IEC) (European)
2 ch × 180 W at 6 ohms, 1 kHz, 2 ch driven of 1% THD
Maximum Effective Output Power (North American)
200 W at 6 ohms, 1 kHz, 2 ch driven of 10% THD
Maximum Effective Output Power (European)
200 W at 6 ohms, 1 kHz, 2 ch driven of 10% THD
Dynamic Power (*)
* IEC60268-Short-term maximum output power
300 W (3 Ω, Front)
250 W (4 Ω, Front)
150 W (8 Ω, Front)
THD+N (Total Harmonic Distortion+Noise)
0.08% (20 Hz - 20,000 Hz, half power)
Input Sensitivity and Impedance
200 mV/47 kΩ (LINE (RCA))
3.5 mV/47 kΩ (PHONO MM)
Rated RCA Output Level and Impedance
1 V/470 Ω (PRE OUT)
1 V/470 Ω (SUBWOOFER PRE OUT)
200 mV/470 Ω (ZONE 2 LINE OUT)
Phono Maximum Input Signal Voltage
70 mV (MM 1 kHz 0.5%)
Frequency Response
10 Hz - 100 kHz/+1 dB, –3 dB (Direct/Pure Audio)
Tone Control Characteristics
±10 dB, 20 Hz (BASS)
±10 dB, 20 kHz (TREBLE)
Signal to Noise Ratio
106 dB (IHF-A, LINE IN, SP OUT)
80 dB (IHF-A, PHONO IN, SP OUT)
Speaker Impedance
A,B: 4 Ω - 16 Ω
A+B: 8 Ω - 16 Ω
Bi-Wiring: 4 Ω - 16 Ω
Headphone Rated Output
80 mW + 80 mW (32 Ω, 1 kHz, 10% THD)
Supported impedance of Headphones
8 Ω - 600 Ω
Headphones Frequency Response
10 Hz - 100 kHz
 Tuner Section
FM Tuning Frequency Range
87.5 MHz - 107.9 MHz (North American)
87.5 MHz - 108.0 MHz, RDS (European)
50 dB quieting sensitivity (FM MONO)
1.0 μV, 11.2 dBf (IHF, 75 Ω)
AM Tuning Frequency Range (North American)
530 kHz - 1710 kHz
DAB Tuning Frequency Range (European)
174.928 MHz - 239.200 MHz
Preset Channel
40