23
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
2.1 Channel System (Bi-wiring the Speakers)
a
You can connect speakers that support bi-wiring to this unit. Connect the treble and bass correctly. Be sure to remove
the jumper bar connecting between the woofer jacks and tweeter jacks of the Bi-wiring supported speakers. Refer to the
instruction manual of your speakers as well.
• As shown on the illustration, the wiring terminals of SPEAKERS B are connected to the tweeter and SPEAKERS A are
connected to the woofer. However, wiring them the other way around is also possible.
"Speaker Setup" settings during
Initial Setup ( p101)
Speaker Setup
Specifies whether the powered subwoofer is connected or not.
Next
< >
Speaker Impedance
6ohms or above
Subwoofer
Speaker B
Yes
Bi-Wiring
Zone 2 Lineout
Zone 2
• Subwoofer: Yes
(Select "No" when not using a
Subwoofer)
• Speaker B: Bi-Wiring
• Zone 2 Lineout/(Preout): Any
value ( p85)
• Speaker Impedance:
4 ohms: When any of the
connected speakers have 4
Ω or more to less than 6 Ω
impedance.
6 ohms or above: When the
connected speakers all have 6
Ω or more impedance.
a: 22° to 30°
1,2 Front Speakers
3 Powered Subwoofer
For high-
frequency
For low-
frequency
To Next Page
Loading...
