Onkyo TX-8390 - Page 98

98
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
of lossy compressed les such as MP3 will be improved. The setting can be set
for each input. This works in signals whose sampling frequencies are 48 kHz or
less.
• It cannot be set if the listening mode is Pure Audio or Direct.
 AccuEQ
AccuEQ: Enable or disable the equalizer function that corrects for sound
distortion caused by the acoustic environment of the room. Select "On" to enable.
The setting can be set for each input.
Manual Equalizer: Select "Preset 1" to "Preset 3" congured in "2. Speaker"
- "Equalizer Settings" on the Setup menu. When this is set to "Off", the same
sound eld setting is applied to all ranges.
 Level
Subwoofer: Adjust the speaker level of the subwoofer while listening to the
sound.
• If you set the unit to the standby mode, the adjustments you made will be
restored to the previous statuses.
Direct: Switches to the Direct mode. Processing that affects sound quality is shut
down, and sound closer to the original is reproduced.
Bass: Enhance or moderate the bass range of the front speakers.
• It cannot be set if the listening mode is Pure Audio or Direct.
Treble: Enhance or moderate the treble range of the front speakers.
• It cannot be set if the listening mode is Pure Audio or Direct.
Balance: Adjust the balance of the sounds output from the left and right
speakers.