Onkyo TX-RZ3100 - Page 124

Thesubwooferproducesnosound
WhenyouplaysourcematerialthatcontainsnoinformationintheLFE
channel,thesubwooferproducesnosound.
When"Speaker""Crossover""Front"intheSetupmenuissetto"FullBand"
andduring2chinputsuchasfromtheTVormusic,thelowrangeelementswill
beoutputfromthefrontspeakersratherthanfromthesubwoofer.Ifyouwould
ratheroutputfromthesubwoofer,makeoneofthefollowingsettings.
– Change"Front"settingtothecrossoverfrequencyvalueotherthan"Full
Band":
Therangebelowthefrequencyyouspecifywillbeoutputfromthe
subwooferratherthanthefrontspeakers.Wedonotrecommendchanging
thisifyourfrontspeakershavegoodlowrangereproductioncapabilities.
– Change"DoubleBass"settingto"On":
Thelowrangeelementswillbeoutputfromboththefrontspeakersandthe
subwoofer.Thismaymeanthatthereistoomuchbass.Werecommend
thatyoudonotchangethesettingorchange"Front"settingtothe
crossoverfrequencyvalueotherthan"FullBand"ifthishappens.
Troubleshooting