Onkyo TX-RZ3100 - Page 26

2. Selectthefrequencywith / ,thenadjusttheattenuationwith / .The
frequencycanbeselectedbetween"63Hz"and"250Hz".Attenuation
canbeselectedbetween"0.0dB"and"12.0dB"(0.5dBintervals).
3.AudioAdjust
Makeadvancedsettingssuchasthoserelatedtomultiplexaudio,settingsforthe
LFElevel,orthoserelatedtothevolumeofthisunit.
1.Multiplex/Mono
MultiplexInputChannel
DefaultValue:Main
Settheaudiochannelorlanguagetobeoutputwhenplayingmultiplexaudio
ormultilingualTVbroadcastsetc.
"Main":Mainchannelonly
"Sub":Subchannelonly
"Main/Sub":Mainandsubchannelswillbeoutputatthesametime.
Ifmultiplexaudioisbeingplayed,"1＋1"willbedisplayedwhen onthe
remotecontrollerispressed.
MonoInputChannel
DefaultValue:Left+Right
Settheinputchanneltouseforplayingany2chdigitalsourcesuchasDolby
Digital,or2chanalog/PCMsourceintheMonolisteningmode.
"Left":Leftchannelonly
"Right":Rightchannelonly
"Left+Right":Leftandrightchannels
MonoOutputSpeaker
DefaultValue:Center
SelectthespeakertooutputmonauralaudiointheMonolisteningmode.
"Center":Audioisoutputfromthecenterspeaker.
"Left/Right":AudioisoutputfromthefrontL/Rspeakers.
Ifanitemcannotbeselectedeventhoughconnectioniscorrect,check
thatthesettingsin"2.Speaker""Configuration""SpeakerChannels"
matchesthenumberofconnectedchannels.
2.Dolby
LoudnessManagement
DefaultValue:On
WhenplayingDolbyTrueHD,enablethedialognormalizationfunctionwhich
keepsthevolumeofdialogatacertainlevel.Notethatwhenthissettingis
Off,theLateNightfunctionthatallowsyoutoenjoysurroundatlowvolumes
isfixedtooffwhenplayingDolbyDigitalPlus/DolbyTrueHD.