Onkyo TX-RZ3100 - Page 52

FirmwareUpdate
UpdatingtheFirmwareviaNetwork
Preparation:
Checkthattheunitisturnedon,andtheconnectiontotheInternetissecured.
Turnoffthecontrollercomponent(PCetc.)connectedtothenetwork.
StopanyplayingInternetradio,USBstoragedevice,orservercontent.
Ifthemultizonefunctionisactive,turnitoff.
If"HDMICEC"issetto"On",setitto"Off".
– Press ontheremotecontroller.Then,afterselecting"5.Hardware"
"HDMI"andpressingENTER,select"HDMICEC"andselect"Off".
＊Thedescriptionmaydifferfromtheonscreendisplaybutthatwillnot
changethewaytooperateorthefunction.
Update
1. Press ontheremotecontroller.
TheSetupmenuisdisplayedontheTVscreen.
2. Select"7.Miscellaneous""FirmwareUpdate""UpdateviaNET"withthe
cursorsinorder,thenpressENTER.
If"FirmwareUpdate"isgrayedoutandcannotbeselected,waitforawhile
untilitstartsup.
Youwillnotbeabletoselect"UpdateviaNET"ifthereisnothingtoupdate.
Settings