Onkyo TX-RZ3100 - Page 53

3. PressENTERwith"Update"selectedtostartupdate.
Duringtheupdate,theTVscreenmaygoblackdependingontheupdated
program.Inthatcase,checktheprogressonthedisplayoftheunit.TheTV
screenwillremainblackuntiltheupdateiscompleteandthepoweris
turnedonagain.
"Completed!"isdisplayedwhentheupdateiscomplete.
4. Press ON/STANDBYonthemainunittoturntheunitintostandbymode.The
processiscompletedandyourfirmwareisupdatedtothelatestversion.
Donotuse ontheremotecontroller.
IfanErrorMessageisDisplayed
Whenanerroroccurs,"＊＊＊Error!"isdisplayedonthedisplayoftheunit.("＊"
representsanalphanumericcharacter.)Checkthefollowing:
ErrorCode
＊01,＊10：
Ethernetcablenotfound.ConnecttheEthernetcableproperly.
＊02,＊03,＊04,＊05,＊06,＊11,＊13,＊14,＊16,＊17,＊18,
＊20,＊21：
Internetconnectionerror.Checkthefollowing:
– Therouteristurnedon
– Thisunitandtherouterareconnectedviathenetwork
Trytodisconnectandthenconnectagainthepowertotheunitandrouter.This
maysolvetheproblem.IfyouarestillunabletoconnecttotheInternet,the
DNSserverorproxyservermaybetemporarilydown.Checktheservicestatus
withyourISPprovider.
Others
DisconnectthenreconnecttheACpowercord,thenrepeatfromthebeginning.