Listening to Radio Broadcasts
[
L
FM MODE
,&IT
TUNER
One of the features of the TX-SR701/701E/601/601E that is most
frequently used is its ability to play FM and AM broadcast radio
stations. The TX-SR701/701E/601/601E provides a number of
listening modes perfect for lislening to the radio and getting the
most out of your audio sys/em. Also, by presetting radio stations
that you listen to frequently, you can select them easily by pressing
the CH ÷/::" button on the remote controller.
Tuning into a radio station
1. Press theTUNER input source button. T.....
Each time you press the TUNER button, the _._.,
input source changes between AM and FM.
\\
2. Using theTUNING • and • buttons
on the front panel, tune into the
station you desire.
Tuned in stereo _ _ Auto mode
Fi4. -;=:S:=.i O..,-KL.--- H
I I
Band Frequency "FM STEREO"
(Lights red)
• The tuner frequency changes in 100-kHz (or 50-kHz)
increments for FM and 10-kHz (or 9-kHz) increments for
AM.
• You can press the TUNING • or • button continuously for
more than 0.5 seconds to scan for an FM station in the
direction of the button you pressed (FM auto tuning mode).
Afler you release the button and a sta/ion is received in
stereo, the scanning stops.
• The European model allows you to receive RDS broadcasts.
See page 39 for more informa/ion regarding tuning into
RDS broadcasts.
Listening to a stereo radio station (FM mode)
When you tune inlo a radio station, • TUNED _1 _MMODE
indicator appears in the display. If you tune
into an FM sta/ion in s/ereo, then "FM
STEREO" appears. If the signal is weak, it
may be impossible to tune into the station in
stereo. In such a case, press the FM MODE
button on the front panel. 'Ihe AUTO
indicalion disappears and the radio station is
output in the monaural mode. 'I_ return to
stereo, press the FM MODE button again.
"AUTO" appears. Some inler-sta/ion noise
may be heard, but the sound will not cut in and
out as it would if stereo was selected.
37
To Next Page
Loading...
