Need help?Do you have a question about the ontime AVC118 and is the answer not in the manual?
General| Brand | ontime |
|---|---|
| Model | AVC118 |
| Category | Controller |
| Language | English |
Technical specifications of the AVC-118 controller, including power, motor, and working temperature.
Outlines the function of each terminal connector on the controller.
Defines signals and functions for the J1 connector to the CNC controller.
Defines signals and functions for the J2 connector for power and motor control.
Explains the connection and function of the J4 terminal for arc voltage input.
Explains the connection and function of the J5 terminal for shield cap signal.
Details the procedure for setting the working arc voltage via the menu.
Explains the procedure for setting the initial height setup (IHS) time.
Details the procedure for setting the pierce time.
Describes how to perform the Initial Height Setup (IHS) test.
Explains how to perform the arc test procedure.
Cautions against changing inner parameters without expert knowledge.
Defines the arc voltage toleration range and its effect on auto height control.
Defines the sensitivity to arc voltage deviation for stable positioning.
Defines the range for intelligent arc voltage adjustment to prevent collisions.
To Next Page