User Manual v.2.2
OD5+ Serie
OPAL – Your AutoID System Integrator
opal-holding.com
- 20 -
2.9 Dump Mode
When the printout result doesn’t match to the label format settings, it is recommended to cahnage into the
Dump Mode to check whether any mistake exists in data transmission between the printer and the PC.
For example, when printer receives 8 commands, yet without processing these commands, only printing
out the contents of commands, this will confirm whether the commands were received correctly or not. To
enter the Dump Mode, please do as follows:
1. Load media into the printer.
2. Press and hold the FEED button while turning the Power switch to the "On" position (-).
3. Release the Feed button and the printer will perform the Autosensing automatically.
4. After a short delay, a test label will be printed out and the printer will enter in Dump mode.
To cancel (get out of the Dump Mode), press the FEED key, the printer will automatically print out “OUT
OF DUMP MODE”. This indicates that the printer is back in the standby mode.
Note: As second option to get out of the Dump Mode you can power off the printer.
To Next Page
Loading...