Openpath Core Series - Page 29




3. While still holding down the ADMIN button, reconnect the power, and continue 
to hold the button for another 15 seconds. If resetting a Controller Board, you 
should see two POWER LEDs light up in the top left corner. 
4. Wait 15 minutes before PROVISIONING THE ACU 


Figure 22 : ADMIN button on Controller Board (left) and Core Board (right) 
PROVISIONING THE ACU 
Provisioning the ACU means registering it in the Control Center and getting it up and 
running with the latest firmware. You will need to re-provision in the case of 
RESETTING THE ACU . 

Note: If you ’ re provisioning ACUs for a customer account, the customer org will need 
to be created by Openpath first. 
REQUIREMENTS 
● Meet all NETWORK REQUIREMENTS 
● Connect the ACU to the Internet via Ethernet 
● Install the Open Admin app 
○ iOS App Store 
○ Google Play Store 

Version 1.8 
© Openpath 2020 
Page 29 
