30 Operating the System
DS2200 User Manual - OPEX Corporation use only - not for distribution
The Page Type buttons allow the operator to designate the page type of
the next document. The Page Type buttons will only be available if they
have been activated for the current job.
Rotate the image of the selected document. Use the three rotate
buttons to position the image as desired. These buttons will only be
available if activated for the current job.
Adjust the settings in the Capture Parameters window to enhance the
quality of the output images. See “Adjusting image quality” on page 51.
Press a Rescan button to replace a previously scanned image with a
new one. See “Rescanning documents” on page 51 for more informa-
tion.
Delete a document from the batch. The Delete buttons, if enable in the
current job, are only available when the machine is stopped. See
“Deleting documents from the batch” on page 52.
Void the selected document or transaction. The Void buttons are only
available if activated for the current job. See “Voiding documents and
transactions” on page 53 for more information.
End the current Transaction. This button will only be available if it has
been activated for the current job.
Start a New Batch. This button will only be available if it has been
activated for the current job.
Press the Action button to access the Rescan, New Batch, and Void
buttons. The Action button only appears if two or more of these buttons
(Rescan, New Batch, Void) are enabled.
Stop the machine. This does not end the current batch or transaction.
Close the current batch.
Exit the current job and close the Run screen.
To Next Page
Loading...
