Version 1.0.4 - 2020-07-2826 Translation of original instruction
MH22V│MH22VD
EN
MH22V_MH22VD_GB_3.fm
3.8.1 Cleaning and lubrication
Remove the anti-corrosive agents which has been applied to the milling machine for trans-
port and storage. We recommend you use paraffin for this purpose.
To clean the milling machine, do not use any solvents, nitro-cellulose thinner or other clean-
ing agents that could damage the paintwork. Observe the cleaning agent manufacturer's
information and notes.
Grease all exposed machine parts using an acid-free lubricating oil.
Lubricate the milling machine in accordance with the lubrication schedule. Inspection
and maintenance on page 38
Check that all spindles are running smoothly. All spindle nuts are re-adjustable.
INFORMATION
The milling machine has been painted with varnish. This fact must be taken into account when
selecting your cooling lubricant. Optimum Maschinen Germany GmbH does not accept any lia-
bility for subsequent damages due to unsuitable cooling lubricants. The flashpoint of the emul-
sion must be higher than 140°C. When using non-water-miscible cooling lubricants (oil content
> 15%) with a flashpoint, ignitable aerosol air mixtures might develop. There is a potential dan-
ger of explosion.
3.9 Optional digital display DRO5
The optionally available digital display DRO5 can be attached to the side of the control panel
with screws. The holes are already drilled there from 2021 onwards. The magnetic holder of the
DRO5 included in the scope of delivery is not strong enough to fix the display securely to the
control panel.
To Next Page
Loading...
