Version 1.0.4 - 2020-07-2838 Translation of original instruction
MH22V│MH22VD
EN
MH22V_MH22VD_GB_5.fm
5.2 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Interval Where? What? How?
Start of work,
after every main-
tenance or repair
work
Milling machine
Safety check on page 14
Start of work,
after every main-
tenance or repair
work
Dovetail guides
Oiling
Oil all guide rails.
Every week
Milling table
Oiling
Oil all bare steel surfaces. Use acid-free oil.
Monthly
Clamping bolts
Milling head
firmly tight-
ened
Ensure that the clamping bolt for swivelling the drill head is
firmly tightened.
Every month
Oiler cup
Oiling
Lubricate all oiler cups with machine oil, do not use grease
guns or the like.
To Next Page
Loading...
