REPLACING THE FUSE
If the VCP does not operate when the DC
adapter is connected, the fuse inside the
adapter might be blown. Follow these
steps to replace it.
1. Unscrew the knurled ring at the
plugÕs tip by turning it counterclock-
wise, then turn over the adapterÕs
cigarette lighter plug so the fuse fails
out.
2. If the wires inside the fuse is broken,
replace the fuse with one of the
same type (1
1
/4 x
1
/4-inch 5-amp
fuse, such as RadioSjack Cat. No.
270-1011). When you screw on the
tip, be sure the knurled ring is
screwed firmly onto the plug.
THE FCC WANTS YOU TO
KNOW
Your VCP might cause TV or radio inter-
ference even when it is operating proper-
ly. To determine whether your VCP is
causing the interference, turn off your
VCP. If the interference goes away, your
VCP is causing it. Try to eliminate the in-
terference by:
¥ Moving your VCP away from the TV
or radio.
¥ Connecting your VCP to an outlet
that is on a different electrical circuit
from the TV or radio.
¥ Contacting your local RadioShack
store for help.
24
To Next Page
Loading...
