User Controls
18
Using the Remote Control
Power
Refer to the “Power On/Off the Projector”
section on pages 13-14.
Brightness
Adjust the brightness of the image.
Contrast
Control the degree of difference between
the lightest and darkest parts of the picture.
Image Shift
Shifts the projected image position horizon-
tally.
H. Keystone
/
Adjust image distortion horizontally and
makes a squarer image.
V. Keystone
/
Adjust image distortion vertically and
makes a squarer image.
Zoom
Press “Zoom” button to zoom in and zoom
out of image.
Display Mode
Select the display mode from Cinema,
Bright, TV, sRGB and User.
Menu
Press “Menu” to launch the on-screen
display (OSD) menu. To exit OSD, Press
”Menu” again.
Four Direc-
tional Select
Keys
Use to select items or make
adjustments to your selection.
Select (Enter)
Confirm your item selection.
Overscan
Mask off a few pixels on each edge of the
image to be displayed. Use this function
to adjust if image source happens to have
noise near any edge of the display image.
4:3
Scale the image at a 4:3 aspect ratio.
16:9
Scale the image at a 16:9 aspect ratio.
Native
The input source will be displayed without
scaling.
Letter-Box
Enable the viewing of the letterboxed non-
anamorphically enhanced movie at full
screen width. Part of the original image will
be lost if the image aspect ratio is less than
1.78:1.
To Next Page
Loading...
