Appendices
English
37
If possible, turn off the projector, then unplug the power cord and
wait at least 20 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will
not turn on until the lamp module has been replaced. To replace
the lamp, follow the procedures in the “Replacing the Lamp”
section on page 39.
LED Problems
LED lighting message
Message Reminders
Fan failed:
Over temperature:
Message
Standby/On LED
(Green)
Temp-LED Lamp-LED
Standby State
(Input power cord)
Flashing
Power on (warming)
Lamp lighting
Power off (Cooling)
Error (Lamp fail)
Error (Fan fail) Flashing
Error (Over Temp.)
Steady light =>
No light =>
To Next Page
Loading...
