EN-41
Eco: The VGA-OUT function will not work when the projector is in
standby.
Active: The VGA-OUT and AUDIO-OUT functions will work when the
projector is in standby.
Note
When Power mode (Standby) is set to Eco (<0.5W), the VGA output, Audio pass-through will
be deactivated when the projector is in standby.
Lamp Settings
Lamp Hours
Display the projection time.
Lamp Reminder
Choose this function to show or to hide the warning message when the
changing lamp message is displayed.
Brightness Mode
Bright: Choose “Bright” to increase the brightness.
Dynamic: Choose “Dynamic“ to dim the projector lamp which will lower
power consumption and extend the lamp life by up to 133%.
Eco+: Choose “Eco+” to dim the projector lamp which will automatically
detect the brightness level of the content and reduce lamp power
consumption (up to 70 percent) during periods of inactivity.
Lamp Reset
Reset the lamp hour counter after replacing the lamp.
Optional Filter Settings
Optional Filter Installed
Choose “Yes” if an optional dust filter is installed.
Filter Usage Hours
Display the dust filter’s elapsed operating time (in hours).
Filter Reminder
Sets a filter reminder if timer is up.
Filter Reset
Reset the dust filter hour counter after replacing the dust filter.
Reset
Choose “Yes” to return the display parameters on all menus to the factory
default settings.
To Next Page
Loading...
Need help?
General
