Oracle Acme Packet 1100 User Manual

DRAFT
Proprietary and Confidential
40 Acme Packet 1100 Hardware Installation Guide
MAINTENANCE INTRODUCTION
To force a switchover between Acme Packet 1100 nodes:
1. Confirm that the relevant systems on the acti
ve/standby Acme Packet 1100
systems are synchronized with the show health command. Type show health
and press Enter on each system.
NETNETSBC1# show health
Media Synchronized true
SIP Synchronized true
MGCP Synchronized true
H248 Synchronized disabled
Config Synchronized true
Collect Synchronized disabled
Radius CDR Synchronized disabled
Rotated CDRs Synchronized disabled
Active Peer Address 0.0.0.0
Redundancy Protocol Process (v3):
State Active
Health 100
Lowest Local Address 169.254.1.1:9090
1 peer(s) on 2 socket(s):
SML-STIC-2: v3, Standby, health=100, max silence=1050
last received from 169.254.1.2 on wancom1:0
Switchover log:
Jun 25 19:03:02.029: Active to BecomingStandby
Jun 25 19:04:54.684: Standby to BecomingActive
NETNETSBC1#
NETNETSBC2# show health
Media Synchronized true
SIP Synchronized true
MGCP Synchronized true
H248 Synchronized disabled
Config Synchronized true
Collect Synchronized disabled
Radius CDR Synchronized disabled
Rotated CDRs Synchronized disabled
Active Peer Address 169.254.2.1
Redundancy Protocol Process (v3):
State Standby
Health 100
Lowest Local Address 169.254.1.2:9090
1 peer(s) on 2 socket(s):
SML-STIC-11001: v3, Active, health=100, max silence=1050
last received from 169.254.2.1 on wancom2:0
Switchover log:
active system
synchronized
standby system
applications
synchronized
applications
Figure 6 - 2. Issuing the Show Health Command

Oracle Acme Packet 1100 Specifications

General

Brand	Oracle
Model	Acme Packet 1100
Category	Controller
Language	English