DRAFT
Proprietary and Confidential
MAINTENANCE INTRODUCTION
Acme Packet 1100 Hardware Installation Guide 41
2. Confirm that the two current configurations match by typing display-current-
cfg-version and press Enter at the ACLI prompt.
NETNETSBC1# display-current-cfg-version
Current configuration version is 5
NETNETSBC1#
NETNETSBC2# display-current-cfg-version
Current configuration version is 5
NETNETSBC2#
Note: While the two current configuration version numbers on the two
systems MUST match each other, they do not have to match the shared
running configuration version.
3. Confirm that the running config
uration of each Acme Packet 1100 matches by
typing display-running-cfg-version and pressing Enter at the ACLI prompt.
NETNETSBC1# display-running-cfg-version
Running configuration version is 5
NETNETSBC1#
NETNETSBC2# display-running-cfg-version
Running configuration version is 5
NETNETSBC2#
4. Initiate a switchover on one chassis by typing notify berpd force and pressing
Enter at the ACLI prompt.
NETNETSBC1# notify berpd force
5. Wait for the other Acme Packet 1100 to transition to the standby state. Confirm
that this Acme Packet 1100 is in the standby state by typing show health and
pressing Enter at the ACLI prompt.
NETNETSBC2# show health
Refer to the Upgrade section of the Maintenance and Troubleshooting Guide (400-0063-
40A) for more information.
Chassis Removal
This section explains how to remove the Acme Packet 1100 from an equipment rack.
Caution Always disconnect the Acme Packet 1100 power supply from
the power source when removing a chassis from an
equipment rack.
Removing the
Acme Packet 1100
from an Equipment
Rack
To remove the Acme Packet 1100 from an equipment rack:
1. Disable the power source to the Acme Packet 1100 power supply.
2. Remove the AC power cord from the 12V connector on the chassis.
3. Remove and label all attached network cable
s and console cable from their
respective ports on the chassis.
To Next Page
Loading...
Need help?
General
