Chapter 15
Appendix
15-9
Rating Label Symbol Information
DC (Direct current)
• This equipment is for indoor use and all of the communication wiring is limited to
the inside of the building.
• The switch is the disconnecting device. Turn off switch from any hazard.
The following Bluetooth mark and Declaration ID D029148 is only applicable to models
with the Bluetooth SIG qualification.
Instructions for the correct selection of a suitable Listed Class 2 Power Battery Charger
(Adaptor) including “This product is intended to be supplied by a Listed Battery Charger
(Adaptor) marked “Class 2” and rated output 8.4 V DC, 0.8 A.”
FCC Compliance Information
This device complies with Part 15 FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired
operation.
Information to the User
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and may radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
To Previous Page
Loading...
General