Oracle Sun Fire X2270 M2 - Removing and Installing a PCIe Card (CRU)

Removing and Installing a PCIe Card (CRU)
This section contains the following topics:
■
“How to Remove a PCIe Card” on page 40
■
“How to Install a PCIe Card” on page 41
▼
How to Remove a PCIe Card
See:
“Locations of Internal Server Components” on page 30
Prepare the server for service. See “How to Prepare for Service”on page 21.
Remove the air duct. See
“How to Remove the Air Duct”on page 53.
Disconnect any cables connected to the PCIe card.
To unlock the PCIe card, open the locking latch on the server rear panel.
To remove the PCIe card from the server, slide the card out of the server rear panel and
disconnect the card from the PCIe riser.
Remove any card-specic cabling from the server.
Install the air duct. See
“How to Install the Air Duct”on page 53.
Prepare the server for operation. See
“How to Prepare for Operation”on page 26.
■
“How to Install a PCIe Card” on page 41
BeforeYou Begin
1
2
3
4
5
6
7
8
See Also
Removing and Installing a PCIe Card (CRU)
Sun Fire X2270 M2 Server Service Manual • January, 2012, –1240