Removing and Installing the SP Module (CRU)
This section contains the following topics:
■
“How to Remove the SP Module” on page 59
■
“How to Install the SP Module” on page 60
▼
How to Remove the SP Module
See:
“Locations of Internal Server Components” on page 30
Prepare the server for service. See “How to Prepare for Service”on page 21.
Remove the air duct. See
“How to Remove the Air Duct”on page 53.
Remove any cables that are attached to the rear of the SP module.
Completely loosen the captive screw securing the SP module to the server motherboard.
Pull the SP module upward to disengage the card from the connector and the alignment pin on
the motherboard.
To remove the SP module, slide it slightly forward to clear the rear wall of the server chassis, and
then lift the module from the chassis.
If you are replacing the SP module, see
“How to Install the SP Module”on page 60.
Prepare the server for operation. See
“How to Prepare for Operation”on page 26.
BeforeYou Begin
1
2
3
4
5
6
7
8
Removing and Installing the SP Module (CRU)
59
To Next Page
Loading...
