Oracle Sun Fire X2270 M2 - Replacing the Front I;O Board (FRU)

Reconnect the I/O cable to the I/O board.
Check the routing of all cables for obstructions.
Prepare the server for operation.
“How to Remove the Front I/O Cable” on page 63
Replacing the Front I/O Board (FRU)
Note – The front I/O board is a eld-replaceable unit. It must be replaced by a certied Oracle
Service Technician.
This section contains the following topics:
■
“How to Remove the I/O Board” on page 64
■
“How to Install the I/O Board” on page 66
▼
How to Remove the I/O Board
See:
“Locations of Internal Server Components” on page 30
Prepare the server for service. See “How to Prepare for Service”on page 21.
Remove the air duct. See
“How to Remove the Air Duct”on page 53.
3
4
5
See Also
BeforeYou Begin
1
2
Replacing the Front I/O Board (FRU)
Sun Fire X2270 M2 Server Service Manual • January, 2012, –1264