Orah 4i - HDMI Output; Using the HDMI Video Output; HDMI Resolution and Framerate

To Next Page

To Previous Page

Orah 4i User Guide v1.2.0

HDMI output

I. Using the HDMI video output

The aspect ratio is 16:9 with a resolution up to 4096x2160p. The framerate is up to 30fps.

● Your HDMI device should be plugged in before you power up the stitching unit.

● Using multiple HDMI ports at the same time is currently not supported.

II. HDMI resolution and framerate

The maximum HDMI output resolution you will get is bound to the configured video mode.

Orah 4i delivers video signal over the stitching unit HDMI 2.0 with supports HDMI 4096x2160

resolution at 30fps and above.

The actual Orah 4i output resolution depends on capabilities of the sink HDMI device you plug

to it. Please refer to your third party equipment to check on supported resolutions and

framerates.

For optimal resolution on the HDMI port, we recommend configuring Orah's video mode to 4K

DCI (4096x2048).

This guide is protected under copyright law