Orah 4i - Using Orah 4 i HDMI Output with Blackmagic Design

To Next Page

To Previous Page

Orah 4i User Guide v1.2.0

III. Using Orah 4i HDMI output with Blackmagic Design Decklink

and ATEM equipment

When plugging Orah 4i to a Blackmagic design ATEM switch, you need to plug the HDMI cable

on the switch after it has been connected to Orah 4i HDMI output. You may need to reboot

unplug and replug the HDMI cable on the ATEM switch for the video to display.

Please note that most Blackmagic design equipment will not display any video signal unless

they are configured at the correct resolution and framerate.

This guide is protected under copyright law